Thursday, August 14, 2014
Browse »
home»
indicator
»
tapping
»
telephone
»
Telephone Tapping Indicator
Telephone Tapping Indicator
This simple schema can indicate a misuse or tapping of Telephone line through a loud alarm. The schema is too simple and can be easily assembled on a common PCB. Line voltage of Telephone lines is around 48 volts DC in the On hook state. When the handset is lifted, this voltage reduces to 12 volt DC. This change in voltage level is used to activate the schema.When the switch S1 is closed, schema becomes active and the telephone enters into the armed state.
Telephone Tapping Indicator Circuit diagram
Setting
Connect the schema to Telephone lines using a telephone plug. The free socket of the telephone or Caller ID can be used. Close S1 and adjust VR1 till buzzer stops beeping. Lift the handset. Buzzer should sound. Otherwise, just adjust VR1 till buzzer beeps.
Telephone Tapping Indicator Circuit diagram
The high volt DC from the telephone line passes through R1 and VR1 and bias T1 into conduction. As a result, the collector of T1 goes to ground potential to inhibit T2 from conduction. Buzzer and LED thus remain off. When the handset is lifted, the DC voltage from the telephone lines drops to 12 volts. This turns off T1 and T2 conducts. Buzzer beeps and LED lights indicating that the telephone is using.
Connect the schema to Telephone lines using a telephone plug. The free socket of the telephone or Caller ID can be used. Close S1 and adjust VR1 till buzzer stops beeping. Lift the handset. Buzzer should sound. Otherwise, just adjust VR1 till buzzer beeps.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment