Monday, August 25, 2014
Browse »
home»
circuit
»
diagram
»
flasher
»
high
»
intensity
»
led
»
warning
»
High intensity LED Warning Flasher Wiring diagram Schematic
![High-intensity]()
The flash frequency is about one per second and the LED on-time is about 330 ms. The duty cycle should enable the batteries to power the schema over night. The schema is composed of three parts. Under normal daylight conditions the batteries are charged through diode D4. In darkness, pnp transistor T1 is switched on, supplying battery current to the second part, a low-frequency oscillator comprising T2 and T3.The third part is the LED driver around T4.
It conducts and switches on the LEDs D1-D2-D3 when the collector voltage of T3 swings high. Two LEDs (D1, D2) are 20,000-30,000 mcd high-brightness yellow types and one (D3) is a normal 3-mm red LED for control purposes. Of course it is possible to increase the number of LEDs to obtain higher brightness. However you will run into limitations regarding the maximum collector current of transistor T4. For really high power applications a MOSFET transistor is suggested instead of the common or garden BC547B.
High intensity LED Warning Flasher Wiring diagram Schematic
This schema was designed as a warning flasher to alert road users to dangerous situations in the dark. Alternatively, it can act as a bicycle light (subject to traffic regulations and legislation). White LEDs only are recommended if the schema is used as a bicycle front light (i.e. for road illumination) and red LEDs only when used as a tail light. During the day, the two 1.6-V solar cells charge the two AA batteries. In darkness, the solar cell voltage disappears and the batteries automatically power the schema.
High-intensity LED Warning Flasher Circuit Diagram
The flash frequency is about one per second and the LED on-time is about 330 ms. The duty cycle should enable the batteries to power the schema over night. The schema is composed of three parts. Under normal daylight conditions the batteries are charged through diode D4. In darkness, pnp transistor T1 is switched on, supplying battery current to the second part, a low-frequency oscillator comprising T2 and T3.The third part is the LED driver around T4.
It conducts and switches on the LEDs D1-D2-D3 when the collector voltage of T3 swings high. Two LEDs (D1, D2) are 20,000-30,000 mcd high-brightness yellow types and one (D3) is a normal 3-mm red LED for control purposes. Of course it is possible to increase the number of LEDs to obtain higher brightness. However you will run into limitations regarding the maximum collector current of transistor T4. For really high power applications a MOSFET transistor is suggested instead of the common or garden BC547B.
Author: Jose Luis Basterra - Copyright: Elektor
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment